Results 1 to 3 of 3
  1. #1
    Prospect
    Join Date
    Aug 2018
    City
    san ramon
    State
    California
    Posts
    2

    "Y" harness (for the connection of Electra GLO Saddlebag side markers) problem

    I have 2017 FLHXS and installed Electra GLO Saddlebag side markers.
    (https://www.harley-davidson.com/stor...-GM+PDP+Bottom)

    I need "Y" harness as it is shown in instruction page of Harley Davidson (https://serviceinfo.harley-davidson....0?locale=en_US) for the connection.

    The part# shown as 69200713. But on the instruction page it says it is not sold separately.

    Where can I find this "Y" Harness to make the connection? Or is there anybody who can produce one.

    Thanks
    Visionliner since 1955
    2017 SGS (Hiawatha)
    2011 BMW R 1200GSA (Enterprise)

  2. #2
    Founding Member azglocker's Avatar
    Join Date
    Dec 2015
    City
    Gilbert
    State
    Arizona
    Posts
    508
    Did you buy your kit used? I assume that the bike connection is just a 2-wire accessory plug. You can buy Deutch connectors from the dealer (should be available elsewhere if you know what you're looking for) and then you can make your own y splitter.

    Sent from my SM-G950U using Tapatalk
    2018 Street Glide, Wicked Red.
    SE stage 1
    Mustang seat
    LEDs!

    daily driver. living in AZ, it's always riding season!

  3. #3
    Prospect
    Join Date
    Aug 2018
    City
    san ramon
    State
    California
    Posts
    2
    Thanks.

    This was a present to me.
    The harness has a part# in Harley instruction site, but also says it is not sold separately. (Part#: 69200713)
    I am planning to check the tail light socket at the rear fender and produce one to get power from this end.
    Visionliner since 1955
    2017 SGS (Hiawatha)
    2011 BMW R 1200GSA (Enterprise)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •