I replaced my bars on my 2017 Street Glide two weeks ago and have caused a lot of self inflicted problems. I pinched the left side wires in the handle bar clamp and didn't realize it. I took back apart soldered and heat shrank wires I had crushed and checked for continuity. I have continuity on all four wires. I replaced the blown 5 amp fuse but still nothing works on the left side. What am I missing? Did I fry the switch pack? Any help would be greatly appreciated.....
Nothing working on left swith pack after bar change
- Thread starter scryle205
- Start date
Check that the connector is plugged in inside the switch pack. When I did my bars I accidentally pulled my right side out.
If you can find the pin out, you can also use a small wire (cat 5 cable is 22ga, I've used it before as a jumper) to jump pin to pin and see if the problem is in the switch pack, cable or elsewhere.
Sent from my SM-G950U using Tapatalk
If you can find the pin out, you can also use a small wire (cat 5 cable is 22ga, I've used it before as a jumper) to jump pin to pin and see if the problem is in the switch pack, cable or elsewhere.
Sent from my SM-G950U using Tapatalk
