New Power Vision

[Grizzly24]

Looking for some help from anyone who has experience with or is knowledgeable with the Dynojet Power Vision. I just installed one and flashed with the tune provided by Fuel Moto. I ran Autotune for about 30 miles under various throttle positions and RPMs. I understand the difficulty in getting all the cells to turn red, but was wondering how I get the cells on the two far left columns populated. I've attached a pic of what it looked like after my ride. Any suggestions or help would be appreciated.

TIA

 

[Mojo]

Grizzly- It takes A LOT more riding than 30 miles in all different riding conditions to get populated. I think I remember some guys riding for several weeks to imitate all the engine scenarios needed for the task.

 

[Bluebowtie]

You won't ever get the first column to populate or at least I have not yet and I have thousands of miles auto tuning.


Sent from the mobile leash

 

[hulkss]

Try coasting down hill in gear with the throttle closed.

 

[OldMike]

I don't think all the cells have to be filled.
I did about 3-4 30-45 min sessions, building on the previous map.
You'll end up fine tuning the Fuel Moto base map but probably not be far from it.
Please look around the web for a TON of info about auto tuning with the Power Vision. The dudes at Fuel Moto are very helpful too.