What did you do to, or on your streetglide today?
- Thread starter Mandrew
- Start date
I just ordered a set of Cycle Rama 570-IIs with adjustable push rods, lifters and the install kit from Fuel Moto along with a Jackpot 2-1-2 header and a set of Jackpot High Roller slip ons. I'll be mapping with a Dynojet Power Vision. Hopefully I'll get it done this weekend and still have two or three weeks to ride. It snowed in the foothills this weekend so it wont be long.......
I'm in the process of moving so I had to ride 60 miles to my house since that is where my tools are. Of course that was after I made sure my rear tire was filled with air! It turns out I had a 2 inch sheet metal screw causing a leak. Damn tire (Metzler) had at least 3-5k left on it too. I ordered in a Michelin Commander II. I got to my house and removed the wheel and sat around for a buddy to come get me so I could get the rubber swapped. I have to say that I am impressed. The difference in the ride is amazing. And who cares how cold it is! I have heated gear and was just happy to be riding.
Ride safe.
Ride safe.
I have been away for awhile. We moved from Colorado Springs to Tucson earlier this year (grandkids are a powerful draw!).
I miss the Colorado scenery, but I am getting in a lot more riding here. On most Saturdays, I ride 150-200 miles with my 80 year old father-in-law. Hope I am going that strong when I reach that age!
I miss the Colorado scenery, but I am getting in a lot more riding here. On most Saturdays, I ride 150-200 miles with my 80 year old father-in-law. Hope I am going that strong when I reach that age!
fitted SENA FREEWIRE to give me better boom box integration with headset...now calls dont go walk-about when the dashboard rings! 
still need to figure out full Android compatibility with stuff like Addresses when it comes to navigation etc.
Most of my contacts in the phone have addresses, but NONE show on the bike
still need to figure out full Android compatibility with stuff like Addresses when it comes to navigation etc.
Most of my contacts in the phone have addresses, but NONE show on the bike
Caught a glimpse of it under the cover buried in my garage while digging out the snow shovel again!
Main seal and stator are back where they belong. The Jim’s tool made it so easy. Loaded up the transmission and crankcase with oil. I also got my Diamond Engineering 12 point polished stainless steel bolts installed on my lifter blocks.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Got my new pushrod covers on. I went ahead and replaced all of the O rings, washers, and springs while I was at it. I also ordered a torque adaptor for the rocker box bolts. Tomorrow night I’m doing my rear shocks and Friday night my rocker boxes.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
